KNX Panel Setup

Company:
HDL Granite Panel
Model:
HDL M/MPTL4.1 (Granite Display) [BETA]
Firmware:
V1.0
Overview

The HDL Granite panel includes dedicated support for audio functions. This includes turning the room on/off, changing the volume in a room, scrolling through the sources for the room, pausing/playing the music, selecting the next or previous song, and selecting the next or previous playlist.

In addition, you can of course configure any of the buttons on any page of buttons to execute a CasaTunes command, or sequence of commands using the CasaTunes Scene commands

Panel Configuration

To enable the audio functions using ETS5:

  1. Select the HDL device
  2. Select the Parameter tab
  3. Select Function Configuration and enable Audio Page
  4. Select Audio and configure the settings as shown below
Group Address Configuration

After you have configured the general settings for your HDL panel, you are now ready to associate the Group Addresses that were imported from CasaTunes with the Group Objects for the panel.

Please refer to the "KNX Setup" Tech Note for more information on how to configure the KNX Driver for CasaTunes, how to export the CasaTunes Group Addresses from CasaSetup, and how to import them in ETS 5.

Now using the ETS 5 tool, associate the following CasaTunes Group Addresses for the zone to be controlled by this panel with the Device Group Objects as shown in the image below.

[Image Not available]

Notes
  1. Use the CasaTunes Power command to play/pause music instead of the play/pause commands which affect all rooms that share the same source
  2. Use CasaTunes Playlists instead of Select Lists